Sherwood RD-6502 Guía para resolver problemas descargar pdf (Pagina 16)

ENGLISH

• Each time these buttons are pressed, the tone

mode is selected as follows :

OFF : To listen to a program source without the

 tone effect. ("DIRECT" indicator lights up.)

ON : To adjust the tone for your taste.

("DIRECT" indicator goes off.)

• Each time these buttons are pressed, the tone is

selected as follows :

 BASS  TRBL (treble)  TONE ON 



When the TONE is set to ON to adjust the tone (bass and treble).

• The tone level can be adjusted within the range of

-10 ~ +10 dB.

• In general, we recommend the bass and treble to

be adjusted to 0 dB (flat level).

• Extreme settings at high volume may damage your

speakers.

• To complete tone adjustment, repeat the above

steps 11 and 12.

• If the tone display disappears, start from the step 9

again.

11. Press the CURSOR UP()/DOWN() buttons to select the desired tone.

12. Press the CURSOR LEFT()/RIGHT() buttons to adjust the selected tone as desired.

10.

Press the CURSOR LEFT()/RIGHT() buttons to select the desired tone mode.

Adjusting the tone (bass and treble)

9. Enter the tone mode.

• The tone mode is displayed for several seconds.

Note :

• When the EXTERNAL IN is selected as an input

source, you can neither select the tone mode nor

adjust the tone.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Sin comentarios

Sherwood RD-6502 Guía para resolver problemas Pagina 16