Sherwood R-903R Guía para resolver problemas descargar pdf (Pagina 26)

Adjust the level of the selected channel

as desired.

Repeat the above steps 1 and 2 to adjust each

channel level.

Presetting and Calling the channel levels

Perform the steps 1 to 3 in “Adjusting

each channel level” on page 25~26 to

adjust each channel level you want.

SETUP

MEMORY

Press the SETUP button for more than 2

seconds, then it enters the setup mode. While

displaying the setup mode, press this button

short repeatedly until “P CALL” is displayed.

Confirm your decision.

ADJUST

TUNING/PRESET

”P CALL” : When calling the preset channel

levels.

“P MEMORY” : When storing the adjusted

channel levels in the preset

memory.

While displaying “P CALL”, select “P

MEMORY” with buttons below.

DECODING

TUNE MODE

• The adjusted channel levels has now been stored

in the preset memory.

• When using this function with remote control unit,

press OSD button and refer to page 38~40.

• If the channel display disappears, start from the

step 1 again.

• You can store the adjusted channel levels in the memory. If you change the channel levels and want to

hear with preset levels, you can call them again.

• Select “P CALL” with performing the above steps 2 to 4.

• Then the current channel levels are changed to the preset ones.

Presetting the channel levels

Calling the channel levels

CH/LEVEL

ENGLISH

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 50 51

Sin comentarios

Sherwood R-903R Guía para resolver problemas Pagina 26